Leave Your Message
330A-HV 24S ESC Agricultural Drones accessories Agricultural Aircraft parts 24S
24S

330A-HV 24S ESC Agricultural Drones accessories Agricultural Aircraft parts 24S

    Parameter:


    ESC:330A-HV

    Support lithium battery:12-24S

    Throttle pulse width:1050us-1940us

    Compatible signal frequency:50Hz-500Hz

    BEC:No

    Continuous current: :230A

    Peak current: :330A

    (Note: It is necessary to ensure good cooling and ventilation conditions, and the shell temperature is below 80°C)

    weight:1133 g

    size:198*77.2*51 mm (长L*S*H)

    Working temperature:-20℃~65℃

    Input power cord: 7AWG L200mm

    Line number line length: 285 mm


    Features:


    1.Fast response speed, the motor can be completed from idle to full speed in 0.25 seconds

    2.Control algorithm specially optimized for disc brushless motors, with higher stability and better compatibility

    3.Synchronous freewheeling technology, with better throttle linearity and drive efficiency, and automatic energy recovery when the motor decelerates.

    4.Equipped with RPM, error signal output interface

    5.Equipped with 485 communication function


    Protective function:


    1.Voltage protection function: When the ESC is powered on and detects that the voltage is lower than 40V or higher than 105V, the ESC will sound an alarm and not start the motor. This function will be disabled during flight.

    2.Temperature protection: When the ESC detects that the temperature is higher than 110°C during operation, an error signal will be output; when the temperature exceeds 140°C, the ESC will shut down the output and return to normal output after the throttle is returned to zero.

    3.Throttle loss protection: When the ESC detects that the throttle signal is lost for more than 0.3 seconds, the power output will be turned off. After the signal is restored, the previous power output will be restored.


    Throttle stroke setting:


    First, connect the motor and ESC, push the throttle to the highest point, then turn on the power and hear 2 "beep" sounds, then push the throttle to the lowest position. If you hear 1 "Do Mi So" sound, it means the throttle stroke is set successfully.

    DRAWING

    4b5b59b67d0ac7291aee36bba6987e7_副本(1).png

    TEST REPORT

    Warning sound description


    Fault phenomenon

    Alarm tone

    Possible Causes

    Solution

    The motor cannot start after powering on

    The rapid sound of "beep beep beep"

    Throttle not returned to zero

    Turn the throttle to the lowest point

    The motor cannot start after powering on

    Beep, beep, beep,..." (each interval is 1 second)

    The receiver throttle channel has no throttle signal output

    Check whether the transmitter and receiver cooperate normally; check whether the throttle control channel wiring is normal

    Power-on voltage is lower than 40V

    "Beep", "Beep", (each interval is 1 second)

    Battery voltage is too low

    Replace the battery with a suitable fully charged battery

    Power-on voltage is higher than 105V

    "Beep", "Beep", (each interval is 1 second)

    Battery voltage is too high

    Replace the battery with a suitable fully charged battery

    Power-on temperature is higher than 110 degrees

    "Beep", "Beep" (each interval is 1 second)

    ESC temperature is too high

    ESC cooling